Linear position, rotary (angular) position, and tilt sensors by Everight Position, Positek, Netzer, Gill, Zettlex, and Posital
Positek: for high-performance industrial applications
 
HomeApplications & Case StudiesFind a Representative or DistributorOutside North America, Click Here
Positek Linear Position SensorsPositek Rotary Position & Tilt SensorsPositek Intrinsically Safe SensorsPositek LVIT/RVIT Technology
Help Desk

Contact Us:
Phone: 856-727-9500
FAX: 610-672-9663
info@evrtp.com

Product Specifications

 

P100: LIPS 100 linear-cylinder position sensor

P100
LIPS 100 Linear-Cylinder Position Sensor

Position feedback for industrial and scientific applications

Available in any travel from 20mm to 600mm.


  Operating Specifications
Travel
any stroke from 20 mm to 600mm (eg 305mm)

Independant Linearity
<±0.25% up to 450mm
<±0.50% over 450mm at 20°C

Temperature Coefficient
<±0.01%/°C Gain & <±0.01%FS/°C Offset

Resolution
Infinite

Noise
<0.02% FSO

Frequency Response
>10KHz (-3dB);
>300Hz (-3dB); 2 wire 4-20mA

  Output Signal & Output Load
Output Signal
Output Load
0.5 to 4.5 V dc ratiometric
2 K Ohms min

0.5 to 4.5 V dc
2 K Ohms min

± 5V dc
2 K Ohms min

± 10V dc
5 K Ohms min

0.5 to 9.5 V dc
5 K Ohms min

4 to 20mA (2 wire)
300 Ohms @ 24V

4 to 20mA (3 wire sink)
950 Ohms @ 24V

4 to 20mA (3 wire source)
300 Ohms Max

Supply Current
12 mA Typical 20 mA max. (Voltage Versions)

  Environmental Specifications
Temperature Limits
Operating: -40 to +125°C (5V input only); -20 to +85°C
Storage: -40 to +125°C

EMC Performance
Susceptibility: EN 61000-6-2
Radiated: EN 61000-6-3

Vibration
IEC 68-2-6: 10g

Shock
IEC 68-2-29: 40 g

Hydraulic Pressure
350 Bar

Sealing
IP65(connector) / IP67(cable)

  Physical Specifications
Body Diameter
35mm

Body Length (to seal face)
43mm (5V input) - 48mm (Other inputs)

Probe Length (from seal face)
Measurement length + 58mm

Target Tube Length
Measurement length +30mm, ID 7.7mm, OD 9.45mm

Other Dimensions

MTBF
350,000 hrs 40°C Gf

Electrical Connections
Screened 3 core cable or integral connector

Target
A non-magnetic target tube is supplied with the sensor. This can be eliminated if the piston rod is made from non-magnetic steel and is drilled to a specified tolerance.

Contact Us: Phone: 856-727-9500 | FAX: 610-672-9663 | info@evrtp.com

Everight Position Technologies Corporation

Linear Position Sensors | Rotary & Tilt Sensors | Intrinsically Safe Sensors | LVIT/RVIT Technology | Home

© Everight Position Technologies Corporation, 2008
 
© Everight Position Technologies Corporation, 2008