Linear position, rotary (angular) position, and tilt sensors by Everight Position, Positek, Netzer, Gill, Zettlex, and Posital
Distributed in North America by:
Everight Position Technologies Corporation
114 Forrest Avenue, Suite 110, Narberth, PA 19072
856-727-9500 or info@evrtp.com

Located outside North America? Click Here

All-In-One Series

GYcAT Probe

High Performance All-In-One Probe

Thanks to the Surface Mount Technology, the entire signal processing electronics of GYcAT series is integrated into a transducer head. You can get a voltage or current analog signal proportional to a magnet position only by applying a 24V dc power supply directly to the transducer. GYcAT series have alarm output and head is equipped with noise cancellation functions.

Specifications

Non-linearity < ±0.05%FS TYP
Resolution < 0.01%FS
Repeatability < ±0.01%FS
Temperature Drift 40ppm FS/°C
Voltage Output 0-10V or 10-0V / (output current: Max. 5 mA, load: Min. 2 kΩ)
Current Output 4-20 mA or 20-4 mA / (load :Min. 500 Ω)
Alarm Output Open collector 30V 0.1A
Power Supply +24 (±2) VDC (100mA)
Frequency Response Std 1kHz (depending on stroke) sampling
Admissible Pressure 35MPa (Probe rod)
Operating Temperature -20°C-+65°C
Storage Temperature -40°C-+80°C
Vibration 6G (or 40Hz 2mmPP)
Shock 50G(2msec)
Protection IP65

The above mentioned accuracy applies to sensors with an effective stroke of 300mm or more.

Model No.

(1):Effective stroke
15mm-2500mm

(2):Output
A:0-10V
B:4-20mA
C:others (bipolar etc)

(3):Direction of output
(toward probe tip)
D:output data increase
R:output data decrease

(4):Thread
M:M24xP1.0 (Standard)
N:M18xP1.5
U:3/4-16UNF

(5):Sensor rod diameter
blank:Φ10 (Standard)
8:Φ8
14:Φ13.8

(6):Cable connection
CN:Connector (Standard)
G*:Pigtail type
(*:Cable length [m], Standard:1.5m)
Connector:straight or angle type
Connector:only counter connector is supplied. In case cable needed, specify cable length.

Dimensions

Connector Type (Standard)

Pigtail Type (Option)

Material probe head:Al diecast, probe rod:SS304
Standard magnet:No.2PN. Other magnets are available from Magnet Grouping [B].
The tip dead zone length (70mm) depends on the magnet or float type.
The length of the cable should be less than 10m in case of using the voltage output type
and 100m in case of using the current output type.
Connector:Sanwa SNW-1607-PCF (Material:zinc alloy fluoroplastic)
Applied cable diameter:Φ6.6-Φ7.5
Wire size:Less than 0.5mm2

Connection
1 DC24V
2 NC
3 0V
4 SIG COM
5 Voltage output
6 (Current output)
7 Alarm output
*Shield should be connected with 0V at user side.

Everight Position Technologies Corporation | 114 Forrest Ave., Suite 110, Narberth, PA 19072 | 856-727-9500 or info@evrtp.com