Linear position, rotary (angular) position, and tilt sensors by Everight Position, Positek, Netzer, Gill, Zettlex, and Posital
Distributed in North America by:
Everight Position Technologies Corporation
114 Forrest Avenue, Suite 110, Narberth, PA 19072
856-727-9500 or info@evrtp.com

Located outside North America? Click Here

All-In-One Series

GYLS/GYLT Probe

Low Cost ・All-in-one Probe ・ Built-in Controller

Low cost, all-in-one, direct analogue output (4-20mA or 0-10V). Absolute, non-contacting transducer. Improved non-linearity, improved S/N ratio, reduced power consumption. Easy to connect (screw type). Wide temperature operating range. Shock and vibration resistant.

Specifications

Non-linearity < ±0.025%FS TYP
Resolution < 0.01%FS
Repeatability < ±0.01%FS
Temperature Drift < 40ppm FS/°C
Voltage Output Model: GYLS 0-10V or 10-0V / (output current: Max. 5 mA, load: Min. 2 kΩ)
Current Output Model: GYLT 4-20mA or 20-4mA / (load: Min. 500 Ω)
Power Supply +24 (±2) VDC (50mA)
Frequency Response Std 1kHz (depending on stroke) sampling
Admissible Pressure 35MPa (Probe rod)
Operating Temperature -20°C-+80°C
Storage Temperature -40°C-+80°C
Vibration 6G (or 40Hz 2mmPP)
Shock 50G(2msec)
Protection IP67 (10kPa, 30min)

Model No.

(1):Effective stroke
15mm-3500mm

(2):Direction of output
(toward probe tip)
D:output data increase
R:output data decrease

(3):Thread
M:M24xP1.0 (Standard)
N:M18xP1.5
U:3/4-16UNF

(4):Sensor rod diameter
blank:Φ10 (Standard)
8:Φ8
14:Φ13.8

(5):Cable connection
CN:Connector (Standard)
G*:Pigtail type
(*:Cable length [m], Standard:1.5m)
Connector:straight or angle type
Connector:only counter connector is supplied. In case cable needed, specify cable length.

Dimensions

Connector Type (Standard)

Pigtail Type (Option)

Material probe head:Al diecast, probe rod:SS304
Standard magnet:No.2PN. Other magnets are available from Magnet Grouping [GG].
The tip dead zone length (70mm) depends on the magnet or float type.
The length of the cable should be less than 10m in case of using the voltage output type
and 100m in case of using the current output type.
Connector:Omron XS2C-D4S1 (straight type) or D4S2 (L type) (Material:PBT plastic)
Applied cable diameter:Φ5-Φ6
Wire size:0.18-0.75mm2

Connection
1 DC24V
2 0V
3 Output (Current or Voltage)
4 COM
*Shield should be connected with 0V
at user side.
*0V and COM are connected in the head.

Everight Position Technologies Corporation | 114 Forrest Ave., Suite 110, Narberth, PA 19072 | 856-727-9500 or info@evrtp.com