Linear position, rotary (angular) position, and tilt sensors by Everight Position, Positek, Netzer, Gill, Zettlex, and Posital
Distributed in North America by:
Everight Position Technologies Corporation
114 Forrest Avenue, Suite 209, Narberth, PA 19072
856-727-9500 or info@evrtp.com

Located outside North America? Click Here

Compact Series

GYPE2K Probe / GYMSC Controller

Fine Rod ・Small Head Type

The GYPE2K probe is a sensor characterized in a fine rod and a small head. A fine rod (outside diameter Φ4) and a small head expand the design flexibility of the equipment. Standard magnet and float can be used. With the GYMSC controller, it outputs analogue signal of 0-10V or 4-20mA.

Specifications

Non-linearity < ±0.5%FS TYP
Resolution < 0.03%FS
Repeatability < ±0.03%FS
Temperature Drift < ±0.01%FS/°C (probe) / < ±0.01%FS/°C (controller)
Voltage Output 0-10V or 10-0V / (output current: Max. 5mA, load: Min. 2kΩ)
Current Output 4-20 mA or 20-4 mA / (load: Min. 500Ω)
Power Supply +24 (±2) VDC (100mA)
Frequency Response approx 1kHz sampling (Note1)
Admissible Pressure 18MPa (Probe rod)
Operating Temperature -20°C-+80°C (probe) / 0°C-+60°C (controller)
Storage Temperature -40°C-+80°C
Vibration 3G (or 40Hz 1mm PP)
Shock 20G(2msec)
Protection IP64 (probe)
Cable Length 1.5m (Standard) (Option Max.5m)

The above mentioned accuracy applies to sensors with an effective stroke of 100mm or more. Zero/Gain adjustments by trimmer of controller is possible, std within ±3%FS. (Note1) liquid level application: approx 100Hz sampling.

Model No.

(1):Effective stroke
50mm-250mm

(2):Cable length (m)
Standard 1.5m

Thread:M18x1.0, Rod:Φ4

(Note2)
Please use the cable as specified though it is possible to extend to Max.5m if specified in advance. (The cable cannot be extended, nor cut.) The terminal stand or connector etc. can be used to arrange cable length.

(1):Output
A:0-10V
B:4-20mA

(2):Effective stroke
50mm-250mm

(3):Direction of output
(toward probe tip)
D:output increase
R:output decrease

Dimensions

Probe

Controller

Ti Float

Material probe head: SS316, probe rod: SS316
Standard magnet:No.Φ、float:T i-float
The M5 screw installed in the rod tip can be used as float stopper or to fix the sensor.
When the sensor rod part is to be sealed, O ring should be used, refer to detail A drawing.

Everight Position Technologies Corporation | 114 Forrest Ave., Suite 209, Narberth, PA 19072 | 856-727-9500 or info@evrtp.com