Linear position, rotary (angular) position, and tilt sensors by Everight Position, Positek, Netzer, Gill, Zettlex, and Posital
Distributed in North America by:
Everight Position Technologies Corporation
114 Forrest Avenue, Suite 209, Narberth, PA 19072
856-727-9500 or

Located outside North America? Click Here

Compact Series

GYPM Probe / GYPMC Controller

Mini-Type Probe

The sensor head of GYPM probe is more compact. By new design of probe head, screw side dead zone has been shortened to 30mm (Standard). As to tip dead zone, making short to 40mm is possible by option (standard:70mm). Cable out direction is radial. GYPM probe is used in combination with the GYPMC controller, which provides analogue output, 0-10V or 4-20mA, and can also be used in combination with GYHC or GYDC-05 controller, which provides velocity output or digital output.


Non-linearity < ±0.05%FS TYP
Resolution < 0.01%FS
Repeatability < ±0.01%FS
Temperature Drift ±70ppm FS/°C (probe) / ±50 ppm FS/°C (controller)
Voltage Output 0-10V or 10-0V / (output current: Max. 5mA, load: Min. 2kΩ)
Current Output 4-20 mA or 20-4 mA / (load: Min. 500Ω)
Power Supply +24 (±2) VDC (100mA)
Frequency Response Std 1kHz (depending on stroke) sampling
Admissible Pressure 35MPa (Probe rod)
Operating Temperature -5°C-+60°C (probe) / 0°C-+60°C (controller)
Storage Temperature -40°C-+80°C
Vibration 6G (or 40Hz 2mm PP)
Shock 20G(2msec)
Protection IP64 (probe)
Cable Length 1.5m (Standard) (Option Max.100m)

The above mentioned accuracy applies to sensors with an effective stroke of 300mm or more.
Zero/Gain adjustments by trimmer of controller is possible, std within ±3%FS.

Model No.

(1):Effective stroke

(2):Cable length (m)


(2):Direction of output
(toward probe tip)
D:output increase
R:output decrease

(3):Effective stroke




Material probe head:SS304、probe head cap:GFRP50 (nylon 66), probe rod:SS304
Standard magnet: No.2PN. Other magnets are available from Magnet Grouping [GG].
The tip dead zone length (70mm) depends on the magnet or float type.
After fixing the probe, users can adjust the cable direction (360°) by loosening the small
screw on probe HEX parts and turning the probe head.

Everight Position Technologies Corporation | 114 Forrest Ave., Suite 209, Narberth, PA 19072 | 856-727-9500 or